IAM Bad Habits

Anything that doesn't fit elsewhere - doesn't have to be AD related.
User avatar
Horse
Posts: 3558
Joined: Mon Sep 28, 2015 9:20 am

IAM Bad Habits

Postby Horse » Wed Jul 21, 2021 8:30 pm

Well, sort of ;) :bash:

https://www.iamcommercial.co.uk/driving ... bitsJuly21

Wear and tear are inevitable results of driving. But which of your driving habits might be making things worse?

Let’s look into some habits that put more strain on our cars than we might realise.

Dragging the brakes downhill
When descending a hill, you may need to use the brakes and should do so appropriately.

But if you’re in a high gear and using the brakes harder and longer than required, this puts unnecessary strain on the brakes which will result in faster deterioration than if you select a low gear and allow the engine to help manage the speed of the vehicle.

Over-using the brakes could result in over-heating – making them less effective if you need to stop in an emergency. Over-use also results in needing to replace them more often, making driving more expensive.

Flooring the accelerator in a high gear
When you push the accelerator pedal too far at low RPM, the engine has to work extra hard to get up to speed, placing unnecessary strain on the motor. If you get into the habit of shifting gear up early and then stepping on the accelerator, you could be doing long-term damage to your engine.

In situations in which acceleration is necessary and you find yourself at low RPM, it’s better to shift down, accelerate, and shift up again when appropriate.

This is most important when carrying heavy loads or climbing hills.

Overloading your vehicle
As capable as our cars seem to be at lugging around as much as we can squeeze into them, they can be overloaded. The car’s maximum load weight should be in the owner’s manual, and indicates how much we should carry in total.

The more weight you carry in your car, the more stress you’re putting into the brakes, suspension, and drivetrain.

Carrying unnecessary items (golf clubs, fishing gear, and other non-essentials) in the boot of your car, while putting negligible added strain on the car on their own, will affect the vehicle’s fuel economy and emissions output.

Shifting from drive to reverse before stopping
Especially bad in automatic vehicles – drivers should always completely stop moving forward before putting the vehicle in reverse.

Shifting gear before coming to a stop will cause wear and tear on the transmission band, rather than the brake discs and pads, which are serviceable items. Any work on the automatic transmission will be labour-intensive, and therefore costly.

Hitting potholes and speed bumps
Most of us are familiar with the jarring thud of hitting potholes and speed bumps too fast. Reports have shown that a third of all vehicle damage is caused by pothole, so staying vigilant and ensuring they’re avoided is vital.

Impacts can cause cracked or buckled wheels, tyre damage and damage tracking or wheel balancing. Driving too fast over speed bumps can cause all of this as well as damage to the front, rear or underside of your car.

Ignoring warning lights
Some warning lights, like washer fluid or bulb warnings may not require urgent attention – depending on driving conditions. Others, however, need to be investigated straight away.

It’s worth checking your owner’s manual to find out what the warning lights on your dashboard mean and familiarising yourself with the most serious ones so you know which ones to pull over and address immediately when driving.

If the following warnings appear on the dashboard, you’re advised to stop and seek help from your breakdown provider or a reputable local garage:

Engine/ECU
Braking system
Power steering failure
Airbag
Oil pressure
Cooling system
Revving the engine when cold
Cold revving causes abrupt temperature changes that create stress between the engine’s tight-fitting components. Simply start your engine and wait 60 seconds before you set off, and everything will have warmed up for reliable performance.

Riding the clutch
Riding the clutch is a common bad habit, especially during hill starts and heavy traffic. It happens when a driver fails to take their foot off the clutch between gear changes, or uses the clutch in place of the handbrake. This puts extra stress and wear on the clutch – which is considered a ‘wear and tear’ part, and therefore not covered by warranty.

Fully disengaging the clutch and using the footrest to the left of the pedal should be second nature and is important if you want to help keep your vehicle in top condition.

Late braking
Sometimes a sudden hazard will necessitate emergency braking. We should of course be prepared to brake appropriately whenever needed. However, some drivers are in the habit of braking late when it’s not necessary, like when they’re approaching a roundabout or junction.

Heavy braking puts more strain on the braking system, and just like the first point in this list, will put more wear and tear on the braking system than necessary.

You’ll also be much more fuel efficient if you take a more slow, considered approach to driving, and braking well in advance.

Developing good habits and losing the bad ones is a fundamental component of our journeys to becoming better drivers. IAM RoadSmart is proud to offer excellent driver training, which is an extremely effective way to make sure that the habits we’re developing are the right ones.
Your 'standard' is how you drive alone, not how you drive during a test.

User avatar
GTR1400MAN
Posts: 2209
Joined: Fri Apr 29, 2016 12:23 pm

Re: IAM Bad Habits

Postby GTR1400MAN » Wed Jul 21, 2021 10:30 pm

So which are you taking exception to? Nothing jumped out at me, though the junk in the boot is debateable and using engine torque instead of revs is vehicle dependant.
Mike Roberts - Now riding a Triumph Explorer XRT. My username comes from my 50K miles on a Kawasaki 1400GTR, after many years on Hondas of various shapes and styles. - https://tinyurl.com/mikerobertsonyoutube

User avatar
akirk
Posts: 1661
Joined: Sun Sep 27, 2015 6:58 pm
Location: Bristol

Re: IAM Bad Habits

Postby akirk » Wed Jul 21, 2021 10:43 pm

well, starting the engine and letting it sit for 60 seconds -> warmed up car… is not accurate, anyone doing that and then over-revving my m5 is likely to end up as damaged as the car ;)

waremark
Posts: 898
Joined: Fri Oct 02, 2015 9:23 am

Re: IAM Bad Habits

Postby waremark » Wed Jul 21, 2021 11:04 pm

akirk wrote:well, starting the engine and letting it sit for 60 seconds -> warmed up car… is not accurate, anyone doing that and then over-revving my m5 is likely to end up as damaged as the car ;)

Yes, very badly expressed. As I understand it, it is best to drive off quite soon after starting the engine, because the oil may not circulate well at idle, and not to use full performance for up to 15 minutes. Difficult/impossible if joining a fast road in a low power car close to home!

User avatar
jont-
Posts: 1523
Joined: Mon Sep 28, 2015 7:12 am
Location: Herefordshire

Re: IAM Bad Habits

Postby jont- » Thu Jul 22, 2021 5:35 am

I'm curious about how they understand physics. Taking the same amount of kinetic energy out of a vehicle by either hard braking or gentle braking will create the same wear and tear, no? I'm struggling to understand why doing it in a shorter space of time will have a more detrimental effect. Or indeed how it will affect fuel efficiency either (unless you're sacrificing progress for fuel efficiency, in which case why not just drive more slowly and give up being the IAM altogether?).

Carbon Based
Posts: 75
Joined: Tue Sep 29, 2015 8:52 pm
Location: London

Re: IAM Bad Habits

Postby Carbon Based » Thu Jul 22, 2021 5:46 am

jont- wrote:Taking the same amount of kinetic energy out of a vehicle by either hard braking or gentle braking will create the same wear and tear, no?

I seem to remember reading that harder braking means shorter time on the brakes means more time cooling means better performance. Does that result in less wear even though the amount of energy being dissipated is the same?

User avatar
Strangely Brown
Posts: 1018
Joined: Sun Sep 27, 2015 8:06 pm
Location: Sussex

Re: IAM Bad Habits

Postby Strangely Brown » Thu Jul 22, 2021 6:02 am

jont- wrote:I'm curious about how they understand physics. Taking the same amount of kinetic energy out of a vehicle by either hard braking or gentle braking will create the same wear and tear, no? I'm struggling to understand why doing it in a shorter space of time will have a more detrimental effect.


Are they taking about the amount of ablative material removed during harder braking rather than just the energy dissipation? Although, that would be more in-depth than the IAM usually pitch their "advice".

User avatar
jont-
Posts: 1523
Joined: Mon Sep 28, 2015 7:12 am
Location: Herefordshire

Re: IAM Bad Habits

Postby jont- » Thu Jul 22, 2021 6:25 am

Strangely Brown wrote:
jont- wrote:I'm curious about how they understand physics. Taking the same amount of kinetic energy out of a vehicle by either hard braking or gentle braking will create the same wear and tear, no? I'm struggling to understand why doing it in a shorter space of time will have a more detrimental effect.


Are they taking about the amount of ablative material removed during harder braking rather than just the energy dissipation? Although, that would be more in-depth than the IAM usually pitch their "advice".

Again though, why would shorter harder braking remove more material than less braking over a longer period?

I do also remember hearing something similar to what Carbon Based said above about long light braking potentially being more detrimental to brake performance than shorter, harder braking.

I'm also surprised they don't mention rev matching. Shifting down into a low gear badly for engine braking is going to cause far more wear and tear than using the brakes - not to mention brakes are usually pretty cheap and easy to replace, unlike syncros and clutches :roll:

User avatar
Horse
Posts: 3558
Joined: Mon Sep 28, 2015 9:20 am

Re: IAM Bad Habits

Postby Horse » Thu Jul 22, 2021 6:33 am

jont- wrote:I'm curious about how they understand physics. Taking the same amount of kinetic energy out of a vehicle by either hard braking or gentle braking will create the same wear and tear, no? I'm struggling to understand why doing it in a shorter space of time will have a more detrimental effect. Or indeed how it will affect fuel efficiency either (unless you're sacrificing progress for fuel efficiency, in which case why not just drive more slowly and give up being the IAM altogether?).


... is the answer to GTR's question. I wondered where the balance is with 'progress'.
Your 'standard' is how you drive alone, not how you drive during a test.

User avatar
Horse
Posts: 3558
Joined: Mon Sep 28, 2015 9:20 am

Re: IAM Bad Habits

Postby Horse » Thu Jul 22, 2021 7:19 am

waremark wrote:
akirk wrote:well, starting the engine and letting it sit for 60 seconds -> warmed up car… is not accurate, anyone doing that and then over-revving my m5 is likely to end up as damaged as the car ;)

As I understand it, it is best to drive off quite soon after starting the engine, because the oil may not circulate well at idle, and not to use full performance for up to 15 minutes.


When I was unable to drive, every two weeks I ran the engine up to temperature. Typically about half an hour. Since then, on-road, about 2 or 3 miles.
Your 'standard' is how you drive alone, not how you drive during a test.


Return to “General Chat”

Who is online

Users browsing this forum: No registered users and 17 guests